Temp sensor is needed to be calibarated after Firmware update

[wcho]

I never got to save or wrote the numbers down. is there any one who knows how to reset the factory setting or numbers?

thanks!

[Matthias]

you can use the standard calibration values:
ADC1: 677 and ADC2: 319

if there is a difference between the reading and the real value you can adjust this with the function "adjust temperature", this modifies the ADCs in order to match the reading

[wcho]

Thank you, Sir.

you can use the standard calibration values:
ADC1: 677 and ADC2: 319

if there is a difference between the reading and the real value you can adjust this with the function "adjust temperature", this modifies the ADCs in order to match the reading