Results 1 to 3 of 3

Thread: 5.0.1 problems

  1. #1
    Join Date
    19.02.2010
    Posts
    29

    Default 5.0.1 problems

    hi there

    after upgrading to the new f/w my p3ex has stoped controlling my 2 heaters on a pab bar sockets 1,2 have searched on the pab settings and the unit found the bar fine .... manual control frol the control s/w works fine have changed one of the sockets over to alaways on for now but need to solve problem


    tony

    the config of my system p111ex 3 pump doings pump nos 1-4 pab bar 11-16 extra redox card and l4 card simul on l3-4 tunzewave box on l1 tunze powerhead on l2 aquarays on both ports of expanion card 2 x redox probes 1 x temp prob 1 x ph prob 1 x salt water cond prob

  2. #2
    Join Date
    10.03.2009
    Posts
    478

    Default

    On what Operation mode is the probe/sensor set? I had to reset my mode to TwoPosition Controller again... look this up under the temp probe setting.

  3. #3
    Join Date
    19.02.2010
    Posts
    29

    Default

    thanks that was it all had lost that setting


    http://www.aquariumcomputer.com/Foru...lies/smile.gif

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •