Firmware upate over USB - unplug powerbars before!

[Matthias]

Thanks for your feedback.
How did you update? Over onboard USB or converter? With ProfiLuxControl or Flasher Tool?
Any problems during update?

[Ken Good]

I used the serial port. I had no issues. My cord was usb to serial.

Ken

[aqua_digital]

would it be possible for you to try again USB to USB and give me feedback on your findings? This is important information to help me with support cases.

[Ken Good]

I am traveling today, but will do this tonight.

Ken

[Ken Good]

I am sad to report that I tried this as requested with devastating results. The installation over the USB to USB stopped in the middle. DO NOT USE USB TO USB TO INSTALL FIRMWARE "P."

Ken

[aqua_digital]

Hi Ken

I do not think the flash tool can be used with USB to USB it can only be used with RS232 or converter

What I meant was to attempt update using ProfiLux control over direct USB.

You are able to restore ok and then try firmware update over profiLux control USB to USB ?

[Ken Good]

I am trying to restore now. Do I need to use the jumper on the profilux 3 like it says to in the profilux 2 user manual? Cannot seem to find directions to use flasher for p3.

Ken

[Ken Good]

Hi Ken

What I meant was to attempt update using ProfiLux control over direct USB.

You are able to restore ok and then try firmware update over profiLux control USB to USB ?

This is what I tried to do and the system stopped in the middle of the firmware update. It would not go forward and this is where I had to have a crash course in the flasher program (great program by the way).

There is a forum thread on directions for using and it was exactly what I did and had no problem.

Ken