Firmware upate over USB - unplug powerbars before!

***Matthias*** · 01.04.2010, 06:54

Thanks for your feedback.
How did you update? Over onboard USB or converter? With ProfiLuxControl or Flasher Tool?
Any problems during update?

**Ken Good** · 01.04.2010, 13:27

I used the serial port. I had no issues. My cord was usb to serial.

Ken

**aqua_digital** · 01.04.2010, 14:36

would it be possible for you to try again USB to USB and give me feedback on your findings? This is important information to help me with support cases.

**Ken Good** · 01.04.2010, 15:46

I am traveling today, but will do this tonight.

Ken

**Ken Good** · 02.04.2010, 14:30

I am sad to report that I tried this as requested with devastating results. The installation over the USB to USB stopped in the middle. DO NOT USE USB TO USB TO INSTALL FIRMWARE "P."

Ken

**aqua_digital** · 02.04.2010, 14:33

Hi Ken

I do not think the flash tool can be used with USB to USB it can only be used with RS232 or converter

What I meant was to attempt update using ProfiLux control over direct USB.

You are able to restore ok and then try firmware update over profiLux control USB to USB ?

**Ken Good** · 02.04.2010, 14:58

I am trying to restore now. Do I need to use the jumper on the profilux 3 like it says to in the profilux 2 user manual? Cannot seem to find directions to use flasher for p3.

Ken