How do I connect a Powerbar 6D PAB Profilux 3ex. I have put the network cable in and the yellow comm lamp blinkson the power bar, but I can't control it from my Profilux 3EX
/Peter
How do I connect a Powerbar 6D PAB Profilux 3ex. I have put the network cable in and the yellow comm lamp blinkson the power bar, but I can't control it from my Profilux 3EX
/Peter
Did you assign the Powerbar to the ProfiLux as mentioned in the PAB guide in section 2.2?
On the ProfiLux:
System->Configure PAB->Assign devices
you can test if the sockets are reacting as expected:
use the "manual override" in ProfiLuxControl
PLC currently doens't support to configure PAB devices (once they are 'discovered' you can configure them normally in PLC )
PLz check this thread for more info about PAB
http://www.aquariumcomputer.com/Foru...ead.php?t=1395
OK now I've contact to tyhe Powerbar and after I've enabled "digital power only on s1-s4" I now have access to "Program Powerbar" I choose now "numbering of a digital Powerbar" and set start number to 10 and selects "program now" - now nothing happens - If i push the "ready" button I will come back to the main menu but the numbers has not changed at the Powerbar.
I want to change the number because I also have a 4 unit dosing pump, placed on 1 to 4
This is incorrect! You don't have a digital Powerbar - you have a PowerbarPAB!
Again:
Did you assign the Powerbar to the ProfiLux as mentioned in the PAB guide in section 2.2?
Link: http://www.aquariumcomputer.com/Down...n_PAB_V500.pdf
On the ProfiLux (not ProfiLuxControl):
System->Configure PAB->Assign devices
Bookmarks