ProfiLuxControl 5.0.0.11

[Matthias]

new:

- save settings also for firmware below 5.00n possible again
- automatical connection recovery: if a (W)LAN-connection has been disconnected (e.g. shutdown from router or switch or due to a bad connection) ProfiLuxControl tries autom. to recover this connection

[patrick vachon]

with the new soft ware 5.00.11 the problem of disconnection (Code 62) seemed solved! matthias thank you!.

I'll keep you informed if the problem come back, but since this morning no problem.

[mshur]

So far connection is stable for me too..
why can i change webserver passwords? Soon as i try to safe, i lose communication and have to end task profilux control

[Matthias]

why can i change webserver passwords? Soon as i try to safe, i lose communication and have to end task profilux control

when you use PLC 5.0.0.11 with firmware 5.00n you will not have this problem

[boboxx]

hmm Matthias, I still do.... when I'm connected I wil get a delay pause the error and sometimes it will continue and sometime it will be "stuck" in a loop with the same message over and over

[aqua_digital]

9.15am - Just installed and connected

Lets see how long for