Page 1 of 3 123 LastLast
Results 1 to 10 of 21

Thread: tunze nano wave box control

  1. #1
    Join Date
    19.02.2010
    Posts
    29

    Default tunze nano wave box control

    hi

    i have a nano wave box and a wave box kit but im unsure ho to control this from the p3ex

    please advise ... only got the p3 yesterday

    tony

  2. #2
    Join Date
    18.02.2009
    Location
    Kaiserslautern
    Posts
    7,710

    Default

    go to the pump section, do the settings as you like

    then assign function "current pump x" to the 1-10V-interface which is connected to the pump

  3. #3
    Join Date
    19.02.2010
    Posts
    29

    Default

    hi mathes
    by doing that does the pump run in each direction for a very short time as it needs to be set in .01 of seconds to create the wave?

    tony a very new p3 owner

  4. #4
    Join Date
    18.02.2009
    Location
    Kaiserslautern
    Posts
    7,710

    Default

    how is the Wavebox connected to the ProfiLux?

  5. #5
    Join Date
    19.02.2010
    Posts
    29

    Default

    hi mattheis

    as yet its not connected i got a wave box connection kit wich is 1 x y splitter and 1 each tunze 1 and 2 cables

    theres no instructions on how to set this up

    tony

  6. #6
    Join Date
    18.02.2009
    Location
    Kaiserslautern
    Posts
    7,710

    Default

    if you have only one controllable pump you don't need the splitter
    just plug one end of the cable into the ProfiLux (chose L-port, e.g. L1L2), the other end into the Tunze power driver

  7. #7
    Join Date
    19.02.2010
    Posts
    29

    Default

    ok but can you confirm that the nano wave box will work correctly as it runs blowing for 0.xx seconds and then sucks for 0.xx seconds this needs to be in hundreths of a second other wise the wave dies.. the model number for the wavebox is 6206 thanks


    tony
    Last edited by ahellary; 15.03.2010 at 09:52.

  8. #8
    Join Date
    18.02.2009
    Location
    Kaiserslautern
    Posts
    7,710

    Default

    yes, you can adjust the wave time in 0.01s steps

    I recommed that you enter your prefered settings and give it a try

  9. #9
    Join Date
    19.02.2010
    Posts
    29

    Default

    ok thank you for your speed of reply

    i will try it tonight

    and it sucks and blows ? ie the pump runs forwards then backwards

    as i dont want to damage the wave box or the p3ex for that matter .... slowly getting to grips with it


    tony

  10. #10
    Join Date
    18.02.2009
    Location
    Kaiserslautern
    Posts
    7,710

    Default

    I don't know if it sucks and blows, but as far as I know these pumps always only blow

    ProfiLux doesn't make more then sending a speed control command (outputting a voltage) - the same as the Tunze multicontroller does

    hint: when adjsuting the 1-10V-interface in question then set the min voltage = 3V and max = 8V -> then it is identical to the Tunze output

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •