-
PLM-ADIM DI input switching
i am just setting up my Digital input switches, reading the installation manual for the card
if i want to switch digital input 1 then i wire pin 2 though switch and 100Kohm resistor and wired and grounded to pin 8.
just before i wire all these up is this correct or is the below correct.
I initally thought it would have been wire fron pin 1 +10v thought switch wire to pin 2 without resistor but from the instruction i take this is not cottect.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks