Lightbar 3 not running at 100% when controlled by Profilux

[Whitearmy61]

I have my Lightbar 3's set up with the control cable and even though the dimming is set at 100% I'm not getting full power. The system setting is at 100% power. If i run the 2x 80cm bars without control I get a draw of 139w but when I connect them up to the Profilux with the rj45 I get a draw of just 32w?? All relevant settings are at 100% so I'm not sure what I am missing?

Any ideas appreciated.

[Gael]

Hello,

Have you updated the ProfiLux firmware?
Version 7.39 for ProfiLux 4 and V1.18 for ProfiLux Mini/Light (WiFi) are required.
It's best to open a support ticket for direct assistance.
https://www.aquariumcomputer.com/sup...ets-enquiries/

Gaël