fail to switch off leak control

[ymevdv]

Hi all,

I am trying to install my GHL profilux and it is not working out completely. (tried to get the email notifications working, but that was a complete fail both with gmail and yahoo. luckily the push notification does work)

I also installed the leak sensor and leak interface and did a test: the wet sensor went to error and a push notification was sent. So that worked nicely.
However, I now cannot reset the error. Not with the reset button, but also not when I disconnect the leak interface from the profilux and pull the powerplug. After restarting, the level sensor is again activated.

The only way to get rid of the error is to change the status of the level port to "not active".

I also get the following alarm:

level control 1

Alarm: maximum on time exceeded or leakage detected (operation mode leakage detection)

So what am I doing wrong?

thanks,

Yme

[Gael]

Hello,

Open a support ticket so that we can see together.
https://www.aquariumcomputer.com/sup...ets-enquiries/

Gaël

[ymevdv]

Thanks!
I will.

Yme