P4 y Mitras 7206 light cycle programming

[jlruro]

Good morning

Google Translation

I have a synchronization problem between P4 and Mitras 7206 in slave mode

In its light period programming, the P4 is configured to instruct the Mitras 7206 to keep the lighting active until 10:30 p.m.

The time setting is NTP and the time corresponds to the real one

The ignition is carried out correctly at the programmed time

But the shutdown does not, although it is scheduled for 10:30 p.m. it does not disconnect until 12:00 a.m.

I have modified 22:30 to 23:00 and the same result does not disconnect until 0:00

The Mitras if I configure it to autonomous mode if it cycles on off according to programming

But the P4+Mitras 7206 in slave does not

I do not know the reason or if the light cycle programming database has an error that does not allow it

[Vinny]

Hello,

If the problem goes away when the light is on Standalone mode, then it may be an interference issue between the ProfiLux and LX7. Please go to the SYSTEM page and adjust the PWC channel number to something else. Go to the LX7 wireless settings and set the channel to the same number.