Results 1 to 2 of 2

Thread: P4 y Mitras 7206 light cycle programming

  1. #1
    Join Date

    Default P4 y Mitras 7206 light cycle programming

    Good morning

    Google Translation

    I have a synchronization problem between P4 and Mitras 7206 in slave mode

    In its light period programming, the P4 is configured to instruct the Mitras 7206 to keep the lighting active until 10:30 p.m.

    The time setting is NTP and the time corresponds to the real one

    The ignition is carried out correctly at the programmed time

    But the shutdown does not, although it is scheduled for 10:30 p.m. it does not disconnect until 12:00 a.m.

    I have modified 22:30 to 23:00 and the same result does not disconnect until 0:00

    The Mitras if I configure it to autonomous mode if it cycles on off according to programming

    But the P4+Mitras 7206 in slave does not

    I do not know the reason or if the light cycle programming database has an error that does not allow it

  2. #2
    Join Date



    If the problem goes away when the light is on Standalone mode, then it may be an interference issue between the ProfiLux and LX7. Please go to the SYSTEM page and adjust the PWC channel number to something else. Go to the LX7 wireless settings and set the channel to the same number.
    No support or warranty issues over PM!
    Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.

    Creating a support ticket
    For support or warranty issues, create a support ticket by clicking here.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts