Hi,
in most cases firmware 1.44, which gave more torque to the motors, fixed the problem.
I had a few cases where a further increase of torque was necessary, these people got 1.45 from me.
There is still one case I am aware of who needs obviously even a bit more power, I am working with him now.
As soon as I have a final and clear picture I will announce it.
About
I had exactly the same problem with my new ghl doser maxi 2.2! The update to version 1.44 did not bring any improvement either. But i would still run update 1.44.
And here's my solution:
clean the pump, hoses and rollers completely from this grease with kitchen paper! It is best to clean it with a little alcohol at the end. Then spray all parts with a silicone spray. I used one for the food industry. Do not use Vaseline!
Since then I've had no problems with my doser maxi 2.2
This is very interesting. We don't use Vaseline, we use a (very expensive) food grade Silicone based temperature resistant lubricant with higher viscosity so the lubricant wont become too liquid and could drip out of the pump head.
We might investigate if there is a better lubricant for this application.
Matthias
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks