Some help on Tunze 6055

[tmccaf]

I need some help setting this up on the profilux. It seems whatever setting I use seems too fast and never changes. Not sure what I am doing wrong but flow seems too fast.

[Gael]

Hello,

We can help you of course :-)
Please post screenshots of your settings and a little explanation of what you want.

Gaël

[tmccaf]

It seems the flow is too strong.. not sure what it is a good flow for Xenia; Duncan and hammer corals.

[Gael]

Hello,

What is the Tunze controller model used by the pump?
According to your screenshots the minimum voltage you have allowed for the 1-10v output is 3v, it is possible that this is too high and that it prevents the pump from decreasing its power.
It is also possible to reduce the power of the pump at the level of the Tunze controller

Also note that an update will be available in the coming days offering even more advanced settings:
https://www.aquariumcomputer.com/new...h-update-7-32/

Gaël

[tmccaf]

controller is 7090.500 so should the voltage be 1 min and max 8 or?

[tmccaf]

according to this thread:
https://www.reef2reef.com/threads/ma...-pumps.736396/

should be set 0 min and max 6.5v since I have new controller with min of 20% am I correct?

[tmccaf]

not sure what to set this to.

[tmccaf]

It seems if I set to 1 to 7V pump don't turn on till 30%.

[Gael]

Try 2.4v min and 6.5 max.
Then adjust min if too low (pump won't start)

Gael

[tmccaf]

Ok thanks yes that was it. This was driving me nuts.