Results 1 to 5 of 5

Thread: Tunze Turbelle® 6105

  1. #1
    Join Date
    22.02.2009
    Posts
    49

    Default Tunze Turbelle® 6105

    Can the Profilux control the Tunze Turbelle® Stream 2 Controllable Pump 6105 like the older ones without the Tunze controller?
    Would the voltage range be also 3-8 v to control the pump?
    What cable should i buy to connected these to.

    There is not a lot of information out there for these current pumps.



    Luis





    http://www.marinedepot.com/ps_ViewIt...8~isKit~0.html

  2. #2
    Join Date
    19.02.2009
    Posts
    2,976

    Default

    I do not have heard that Tunze have changed something on the connecting because they say you an control it with your existing multicontroller. So, get a Tunze 1 or Tunze 2 cable. 3-8 VDC will be fine on these Pumps also.

  3. #3
    Join Date
    22.02.2009
    Posts
    49

    Default

    If i want to control 2 pumps, what will I need to buy?

    Tunze 1 Cable
    Tunze 2 Cable
    YL2-1 Splitter cable

    One of each? I want to be able to control each pump to be independent of each other within the program.

  4. #4
    Join Date
    22.02.2009
    Posts
    49

    Default

    I think I figure it out, each port has 2 output.

    Hence L1/L2, L3/L4, L5/L6 thats a total of 6 analog output.

    The Splitter Cable just split the port output so you can use the second channel.
    The Tunze 1 and 2 are pin differently to select which channel you want to use within the port.

    I would need all 3 cables then.
    Last edited by Luisagos; 24.03.2009 at 23:12.

  5. #5
    Join Date
    19.02.2009
    Posts
    2,976

    Default

    You are very right.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •