Hi,
I have a Profilux 3 (firmware 5.00m, using Proflix Control 5.0.0.9) with the PLM-DALI module. To the DALI module are 4 Osram Quicktronic Intelligent 1x 35/49/80 ballasts connected.
In the menu System, the DALI option is available, but when I start "New Numbering" I get a disappointing result: 0 found. When I choose "Assign illumin." all the lights switch off. I tried with another cable, with one ballast, etc. etc, but no other behaviour.
Any ideas what goes wrong? Is the DALI module defective, are the 4 (new) ballasts defective?
Harmjan
Bookmarks