Results 1 to 2 of 2

Thread: ph probe error code

  1. #1
    Join Date
    21.05.2019
    Posts
    33

    Default ph probe error code

    Hi,

    when I dip the ph probe into kalk solution to test if it's saturated, it steadily rise up to around 10.5 and then an error code came out as "*** !". what does this mean ? Is it not able to go above that ? I'm expecting saturated kalk to read around 12.4. previously my calibration was set using ph level 7 and 9.

    thanks

  2. #2
    Join Date
    27.05.2015
    Posts
    2,488

    Default

    What you are seeing from your controller is normal.

    This is happening because the pH value of the measured sample exceeds the limit of the displayable pH value. The measurement range is 3.0 - 10.5 pH.
    You can find this along with other limits in page 48 of the ProfiLux 4 Manual.
    No support or warranty issues over PM!
    Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.

    Creating a support ticket
    For support or warranty issues, create a support ticket by clicking here.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •