Results 1 to 4 of 4

Thread: Turning doser off during maintenance event

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Join Date
    29.06.2020
    Posts
    24

    Default Turning doser off during maintenance event

    I am trying to figure out how to turn off my doser pump that I have set up as a ATO when I do a water change. I have the maintenance event set up and it turns off my return pump and flow pumps but I can not figure out how to turn off the doser pump without just turning the power off to it with a switch socket.

  2. #2
    Join Date
    12.04.2015
    Posts
    364

    Default

    Die Kurzform:
    Erzeuge eine Programierbare Logik ATO und nicht Wartungsprogramm.
    Die Programierbare Logik wir einem freien Schaltkanal zugewiesen und die Dosierpumpe diesem Schaltkanal.
    Last edited by Gandalf; 29.05.2022 at 05:37.

  3. #3
    Join Date
    29.06.2020
    Posts
    24

    Default

    That is how I have my ATO set up on switch 64. So if I make my maintenance event shut off switch 64 the ATO will not work during the maintenance event.

    How do I do it for the pumps that are on a dosing schedule?

  4. #4
    Join Date
    12.04.2015
    Posts
    364

    Default

    Nehmen wir mal an Dosierpumpe 1 soll dosieren.
    Dann stellst du Dosierpumpe 1 auf: reagiert auf Schaltkanal 17
    Schaltkanal 17 stellst du auf Programierbare Logic 11
    Programierbare Logic 11 stellst du auf: Dosierpumpe 20 und Programierbare Logic 12
    Programierbare Logic 12 stellst du auf: nicht Wartung 1.
    In Dosierpumpe 20 stellst du deinen Dosierplan ein.
    Es wird dann nur leider mitgezählt, was nicht dosiert wurde. Dein Füllstand wird dir zu hoch angezeigt werden.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •