Hello,

Recently during programming my GHL Profilux 4, it suddenly asked me for a PIN. After going on the manual, I was able to reset the device using FlashUSB and remove the PIN.

Now, the same thing happened again. It is asking me for a PIN. However, no matter how many times I try to complete the "Full Operation" on FlashUSB, it still asks me for a PIN!

I've tried to erase it, and download the program again, with the same result. I've been through all the steps (opening the device, pressing the blue reset button, connecting to the proper COM port) however, its just not working!

Any suggestions would be greatly appreciated. I'm stuck with a bricked device as of now