Results 1 to 3 of 3

Thread: RGB led using 0-10 output and Fibaro controller

  1. #1
    Join Date
    08.12.2021
    Posts
    36

    Default RGB led using 0-10 output and Fibaro controller

    Hey!

    I have the fibaro RGB W led controller. Basically it comes with 4 0-10v inputs and 4 PWM outputs to control a led strip of up to 140W.

    I want to use it to control a backlight panel.

    Can I connect the 0-10v outputs from the Profilux 4 to the Fibaro controller? If so:

    - what cable do I need to get 3 0-10v outputs from the Profilux?
    - the Fibaro RGBW can be configured to have (or not) a pull-up resistor on each 0-10v input. Does the Profilux 0-10v outputs require a pull-up resistor?

    Anything else I should keep in mind?

    Cheers,

  2. #2
    Join Date
    08.12.2021
    Posts
    36

    Default

    For anyone seeing this in the future, the setup works.

    - No pull up resitor needed, i.e. the Fibaro configuration is "no pull up"
    - Used rj12 cable (6 wires) and the relevant pins are pins 2 and 5. Pin 3 was also needed for GND. The mapping is

    - Port 1. Pin 3 goes to Fibaro GND. Pin 2 goes to Fibaro Input 1. Pin 5 goes to Fibaro input 2
    - Port 2: Pin 2 goes to Fibaro Input 3. Pin 5 goes to Fibaro input 4

    I'm actually not using the W channel since my led strip is RGB and not RGBW.

    Hope it helps anyone in the future!

  3. #3
    Join Date
    27.05.2015
    Posts
    2,488

    Default

    Hey,

    I'm glad you got it working. Thank you very much for updating the thread with your findings.
    No support or warranty issues over PM!
    Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.

    Creating a support ticket
    For support or warranty issues, create a support ticket by clicking here.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •