Results 1 to 5 of 5

Thread: Profilux 3 fw update - Conductivity/Salinity expansion card no longer detected

  1. #1
    Join Date
    25.01.2014
    Posts
    5

    Default Profilux 3 fw update - Conductivity/Salinity expansion card no longer detected

    Updated my Profilux 3 to firmware 6.46. Re-added all settings from the .par backup done prior to updating.

    Conductivity/Salinity expansion card no longer detected - Not visible in GCC under System nor in Sensor Overview.

    Advise appreciated

    Thank you in advance

  2. #2
    Join Date
    27.05.2015
    Posts
    2,358

    Default

    If you revert to an older FW such as v6.45, does the expansion card become visible to the P3?
    No support or warranty issues over PM!
    Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.

    Creating a support ticket
    For support or warranty issues, create a support ticket by clicking here.

  3. #3
    Join Date
    25.01.2014
    Posts
    5

    Default

    Tested w. 6.45, 6.43, 6.41 and 6.26 - Same result

    Upgrade was from 6.19 - Sadly I no longer have the FW file available

    Will try to remove expansion card, upgrade, add card to see if detected

  4. #4
    Join Date
    25.01.2014
    Posts
    5

    Default

    Removing the expansion card, upgrading, re-added all settings from the .par backup done prior to updating and then adding the Conductivity expansion card again brought everything back in working order and now w. FW 6.46

  5. #5
    Join Date
    27.05.2015
    Posts
    2,358

    Default

    Thank you for the update. Glad it's working normally for you again.
    No support or warranty issues over PM!
    Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.

    Creating a support ticket
    For support or warranty issues, create a support ticket by clicking here.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •