Hello!
I am going to attempt to Dim a set of BuckPuck LED drivers using the 1-10v interface. I need to set the voltage range to 0 - 5v using the profilux software.
Now the buckpucks are inverted. When fed a 0v signal, they will be at 100% brightness, and a 5v signal means 0% brightness. So if it only goes down to 1v, I lose 140ma (out of 700ma max)
So I need to know, will the 1-10v interface go all the way to 0 if set to in the software? And if so, will there be a smooth transition between 0-1v?
Thanks to anybody who can help.
Ryan
Bookmarks