Results 1 to 3 of 3

Thread: How to remove PAB alarm notification?

  1. #1
    Join Date
    05.12.2019
    Posts
    11

    Default How to remove PAB alarm notification?

    The PAB alarm went off when I was on vacation. A dose maxi had been drowned due to leakage.

    I've physical removed the device from the chain of connected devices but that does not remove/reset the alarm. Still flashes red.

    Have been advised to remove the unit but do not get it completely and wonder if anyone knows how to do so that not everything else resets. Other units in the same chain - like dosers etc..

    I go to SYSTEM, click MAXIMIZE on PAB and then see the device in the list, click on ASSIGN DEVICES to deselect it and get the alarm to stop - but the device is not in the list ..

    How should I be able to mark it as "offline" or not part of the chain of PAB devices?

    What do I do?

    /Andre.

  2. #2
    Join Date
    10.10.2013
    Posts
    988

    Default

    Hi,

    Press Reset PAB and assign other devices after.

    Gaël

  3. #3
    Join Date
    27.05.2015
    Posts
    2,483

    Default

    Do what Gaël suggested.

    The alarm continues to flash because when you originally assigned the Maxi doser, the ProfiLux expects it to be part of the PAB chain. After the device was flooded, it lost communication with the P4 which in-turn meant the PAB-COM alarm would be triggered. It will keep flashing that alarm until it once again detects the same Maxi device.
    No support or warranty issues over PM!
    Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.

    Creating a support ticket
    For support or warranty issues, create a support ticket by clicking here.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •