Can 2 Slimline RGB be connected and controlled from Profilux 3ex?

[almost]

If I get it right I will need:

RS 232 splitter to connect the first Slimline RGB and
RJ 45 to connect the second splitter to the first splitter and the second Slimline RGB on this splitter.

This means that the first Slimline RGB will be on channels 5-7 and the second on on channels 13-15 (by setting the dip switch on the dimmer) so I can even dim them undependably.

Correct?

Can I do the same but using 2 RS232 splitters? Will this set up also work?

[Vinny]

As long as you have a PSU strong enough to power multiple Slimline RGB strips, you can connect them all together using the Slimline splitter. The include cable is then connected to the Mitras Slimline SplitterRS232 RGB port.

[almost]

From the photo of the RS 232 splitter it seems like the Slimline RGB and the Slimline does not have the same type of jack.

So, I am not sure what you said is right, it seems like the Slimline splitter is only for Slimline and not for Slimeline RGB.

Can you please confirm that Slimline splitter can be used with Slimeline RGB?


Can you please also answer me my first question in the post? Can I use 1 RS 232 splitter and 1 RJ45 splitter or 2 RS 232 splitters to connect 2 Slimline RGB and dimm the Slimlines RGB independently from each other (for example the one off and the other in 50% ) ?

[Thilo]

You're correct. The Slimline RGB LEDs can't be connected to the non-dimmable splitter. You'll need a dimmable splitter for each Slimline RGB.
The RS232 version is only needed for the connection to the ProfiLux 3 and only one Mitras Slimline or Lightbar splitter can be connected to the ProfiLux. Additional splitters must be connected to the previous splitter or an Expansion Box.

[almost]

So, if I want to control both Slimline and LBII I will need to connect the one to Profilux (lets say the Slimline) and the other one (lets say the LBII) to Expansion Box. Correct?

Because if you see the reply from Vinny on my post with the subject "Can I dimm Slimline and Mitras 2 lightbar from the same Profilux"? he replies that I can if on the Profilux I have 2 different RS 232 ports available. This is also wrong if I get it right from your reply.

Expansion Box I is it compatible with this function?

[Thilo]

So, if I want to control both Slimline and LBII I will need to connect the one to Profilux (lets say the Slimline) and the other one (lets say the LBII) to Expansion Box. Correct?

Yes, this will work with a Expansion Box 2 with firmware 2.04 or higher.

Because if you see the reply from Vinny on my post with the subject "Can I dimm Slimline and Mitras 2 lightbar from the same Profilux"? he replies that I can if on the Profilux I have 2 different RS 232 ports available. This is also wrong if I get it right from your reply.

I'm not 100% sure, but probably it won't work. But I can say for sure, that it won't be possible to control them with different settings in this case.