Hello,
I am using one of the dosing pump heads on my Doser 2.1 as a min-max ATO. I believe I need to adjust the difference between the sensors, as when the ATO function kicks on, it hits the time limit prior to the reaching the second sensor. The optical sensor is currently right at the bottom of the float sensor, the max speed is set to fast, and the max time is set to 10 minutes. I also have it set (I think) to reset the error automatically; however, it is not resetting it. Instead it is sitting in error until I reset it. Settings attached
Aside from moving the sensors closer, how can I make sure the ATO keeps working even if it hits max time? Also, can I get an email set up if it does error out?
Thanks,
Mike
Bookmarks