Zeige Ergebnis 1 bis 2 von 2

Thema: Measurement Cell on Overflow

  1. #1
    Registriert seit
    20.01.2018
    Beiträge
    3

    Standard Measurement Cell on Overflow

    I'm planning to plumb a measurement cell into my overflow. I expect the overflow to run at about 2000 gph total, but the individual pipes will probably run closer to 1000 gph. This seems like an excessive flowrate to try to run through the measurement cell.

    I was thinking of running a wye off the 1 inch overflow pipe and running that through the measurement cell. After the measurement cell it would return to the overflow pipe. It would look something like this:

    |
    |
    |\
    | \
    | CELL
    | /
    |/
    |
    |

    Does that seem reasonable, or is there a better way to plumb this?

  2. #2
    Registriert seit
    27.05.2015
    Beiträge
    2.155

    Standard

    That looks good to me.

    The measurement cell is best placed in a by-pass anyway.
    No support or warranty issues over PM!
    Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.

    Creating a support ticket
    For support or warranty issues, create a support ticket by clicking here.

Forumregeln

  • Es ist dir nicht erlaubt, neue Themen zu verfassen.
  • Es ist dir nicht erlaubt, auf Beiträge zu antworten.
  • Es ist dir nicht erlaubt, Anhänge hochzuladen.
  • Es ist dir nicht erlaubt, deine Beiträge zu bearbeiten.
  •