Firmware Instructions

**Rick99VT** · 18.02.2010, 00:22

Where are the basic firmware instructions? The PIII manual I downloaded from the aquariumcomputer.com site suggests the instructions can be found on the website, yet I cannot find them anywhere. I see the SMS firmware instructions and all the various firmware updates and profilux controls, but not the instructions.

Thank you

***Matthias*** · 18.02.2010, 07:49

usually you can do the update with ProfiLuxControl without a special tool or extra instructions

only when this update fails you can use the flasher tool to recover the firmware, how to use this tool is described in the ProfiLux manual
if this manual is not enough - in our forum are many posts regarding firmware recovery with this tool

**capri** · 27.02.2010, 09:19

Are there any plans for firmware upgrades to be done by USB flash drives or WLAN? I don't have a laptop. The P3 is 15 meters away so for every firmware update I have to remove everything and then put it back again.

***Matthias*** · 27.02.2010, 09:36

Hi

updates via USB flash drive or WLAN will not be possible. What about an extension cable for the updates?

**capri** · 27.02.2010, 10:36

What extension cables? USB are only good for 5 meters. I have the PL-0083 cable by my computer doesn't have a serial port. Are you planning upgrades using LAN cables?

***Matthias*** · 27.02.2010, 11:23

try it with an 10m extension - in most cases it works because the transmission during the update has not the full speed
here in my office it works without problems

**capri** · 27.02.2010, 16:54

You mean USB to RS232 converter + 10m extension cable + PL0083 cable to the serial port of the P3?

***Matthias*** · 27.02.2010, 17:05

Originally Posted by capri

You mean USB to RS232 converter + 10m extension cable + PL0083 cable to the serial port of the P3?

this will work in any case

but I meant an USB-extension, I am quite sure it will also work even if it is longer than 5m

**jjk_reef00** · 01.05.2010, 06:56

Originally Posted by Matthias

usually you can do the update with ProfiLuxControl without a special tool or extra instructions

only when this update fails you can use the flasher tool to recover the firmware, how to use this tool is described in the ProfiLux manual
if this manual is not enough - in our forum are many posts regarding firmware recovery with this tool

What exactly does that mean. There are obviously steps involved in the firmware upgrade (download software, connect usb, etc...). I want to know what these steps are. Especially because I have an expansion box as well. For the amount of money we pay for these controllers we shouldn't have to rummage through forums, or extensively long manuals to find out how to upgrade firmware. It should be posted in a separate pdf on the same page we download the firmware.