Zeige Ergebnis 1 bis 5 von 5

Thema: skimmer control

  1. #1
    Registriert seit
    08.02.2013
    Ort
    Victoria BC
    Beiträge
    164

    Standard skimmer control

    I have skimmer on switch 5 as a filter but I have to choose 1 to 4 Then in feed pause I checked all four boxes but it only turns off when I use feed pause 4 .After testing a found that if I change filter number it turns off when I start same feed pause. using P3 ex and gcc1131
    profilux 3x wireless enabled 3 ecotech pumps and wireless adapter
    3 Simuspots 2 levl sensors ( min /max)
    4 channel dossing pump 2 PAB 6 outlets
    Temp PH and redox sensors 2 mitras 6100HV
    touch Condutivity sensor wireles card

  2. #2
    Registriert seit
    12.04.2015
    Beiträge
    285

    Standard

    Set the Power Socket 5 of the Skimmer to Programmable Logik 1
    The Programable Logiks are set to:

    G1 = G2 ore G3
    G2 = feedpause 1 or 2
    G3 = feedpause 3 or 4

  3. #3
    Registriert seit
    27.05.2015
    Beiträge
    2.155

    Standard

    As mentioned above, you will need to use Programmable Logic if you want to have the skimmer react to all 4 Feed Pauses. Go to the PL settings page, choose an unused gate, set the function to AND, then select your 1st and 2nd FP. Repeat these same steps, except this time choose your 3rd and 4th FP.

    Once that is done, choose a new PL gate and select the PL function which combines FP1 - FP4.

    Assign this newly made PL function to the socket that is powering your skimmer.
    No support or warranty issues over PM!
    Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.

    Creating a support ticket
    For support or warranty issues, create a support ticket by clicking here.

  4. #4
    Registriert seit
    12.04.2015
    Beiträge
    285

    Standard

    moin vinny, sicher mit dem und? ich währe für ein oder.

  5. #5
    Registriert seit
    08.02.2013
    Ort
    Victoria BC
    Beiträge
    164

    Standard

    Thank you all I have it working ( i think) I went to pro logic and tried several times. Then read some more and found that in the pull down list filter means feed pause. and G1 is pro-logic 1 etc ...
    profilux 3x wireless enabled 3 ecotech pumps and wireless adapter
    3 Simuspots 2 levl sensors ( min /max)
    4 channel dossing pump 2 PAB 6 outlets
    Temp PH and redox sensors 2 mitras 6100HV
    touch Condutivity sensor wireles card

Forumregeln

  • Es ist dir nicht erlaubt, neue Themen zu verfassen.
  • Es ist dir nicht erlaubt, auf Beiträge zu antworten.
  • Es ist dir nicht erlaubt, Anhänge hochzuladen.
  • Es ist dir nicht erlaubt, deine Beiträge zu bearbeiten.
  •