Results 1 to 2 of 2

Thread: Conductivity probe keeps drifting

  1. #1
    Join Date
    15.01.2021
    Posts
    1

    Default Conductivity probe keeps drifting

    I recently bought the Profilux 4 Mega set and installed it in my aquarium. The initial setup and probe calibration went with ease. The only problem I have is with the conductivity probe. The reading after the calibration is spot on (checked with calibrated Hanna and refractometer). But shortly thereafter the reading keeps dropping. None of the probes are anywhere near any power cables and I have calibrated the conductivity twice. Am I doing something wrong?

  2. #2
    Join Date
    04.11.2015
    Posts
    1,062

    Default

    Hi,

    open a support-ticket, where we will take care of this. Please attach there also the ProfiLux 4's settings and sensor data:
    https://www.aquariumcomputer.com/sup...ets-enquiries/
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •