Page 1 of 2 12 LastLast
Results 1 to 10 of 12

Thread: Some help on Tunze 6055

  1. #1
    Join Date
    31.12.2019
    Posts
    70

    Default Some help on Tunze 6055

    I need some help setting this up on the profilux. It seems whatever setting I use seems too fast and never changes. Not sure what I am doing wrong but flow seems too fast.

  2. #2
    Join Date
    10.10.2013
    Posts
    994

    Default

    Hello,

    We can help you of course :-)
    Please post screenshots of your settings and a little explanation of what you want.

    Gaël

  3. #3
    Join Date
    31.12.2019
    Posts
    70

    Default

    It seems the flow is too strong.. not sure what it is a good flow for Xenia; Duncan and hammer corals.
    Attached Files Attached Files

  4. #4
    Join Date
    10.10.2013
    Posts
    994

    Default

    Hello,

    What is the Tunze controller model used by the pump?
    According to your screenshots the minimum voltage you have allowed for the 1-10v output is 3v, it is possible that this is too high and that it prevents the pump from decreasing its power.
    It is also possible to reduce the power of the pump at the level of the Tunze controller

    Also note that an update will be available in the coming days offering even more advanced settings:
    https://www.aquariumcomputer.com/new...h-update-7-32/

    Gaël
    No support or warranty issues over PM!
    Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.

    Creating a support ticket
    For support or warranty issues, create a support ticket by clicking here.

  5. #5
    Join Date
    31.12.2019
    Posts
    70

    Default

    controller is 7090.500 so should the voltage be 1 min and max 8 or?

  6. #6
    Join Date
    31.12.2019
    Posts
    70

    Default

    according to this thread:
    https://www.reef2reef.com/threads/ma...-pumps.736396/

    should be set 0 min and max 6.5v since I have new controller with min of 20% am I correct?

  7. #7
    Join Date
    31.12.2019
    Posts
    70

    Default

    not sure what to set this to.

  8. #8
    Join Date
    31.12.2019
    Posts
    70

    Default

    It seems if I set to 1 to 7V pump don't turn on till 30%.

  9. #9
    Join Date
    10.10.2013
    Posts
    994

    Default

    Try 2.4v min and 6.5 max.
    Then adjust min if too low (pump won't start)

    Gael
    No support or warranty issues over PM!
    Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.

    Creating a support ticket
    For support or warranty issues, create a support ticket by clicking here.

  10. #10
    Join Date
    31.12.2019
    Posts
    70

    Default

    Ok thanks yes that was it. This was driving me nuts.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •