Results 1 to 3 of 3

Thread: Tunze Streams not controlled by P4

  1. #1
    Join Date
    13.03.2009
    Location
    new york
    Posts
    255

    Default Tunze Streams not controlled by P4

    Hello guys,
    Need a little help here

    Setting up 2x6105 Streams in addition to my 4 MP40’s but seems like there is a problem to control Tunze’s. I set up permanent opposite option with Sunis wave, assigned 1-10v and so on . I see pumps are changing speed in GCC but when i put my hand a front of the pump i feel constant flow without and changes . Please see my screen shots, where is my error?





    Sent from my iPhone using Tapatalk

  2. #2
    Join Date
    09.11.2017
    Posts
    1,476

    Default

    Have you changed the mode to "external control" on the Tunze Turbelle Controller?
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  3. #3
    Join Date
    13.03.2009
    Location
    new york
    Posts
    255

    Default

    Quote Originally Posted by Thilo View Post
    Have you changed the mode to "external control" on the Tunze Turbelle Controller?
    Yes, of course... Both pumps react to feed mode or no current . Seems that both pumps working at the same rate, constant flow...

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •