Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: pH-Sonde kalibrieren an PL3ex mit Firmware 6.29 und firmware update

  1. #11
    Join Date
    09.11.2017
    Posts
    1,476

    Default

    Bei 6.29 verwenden Sie am besten das GHL Control Center. Was auf der Sensorseite angezeigt wird, sollte aber alles passen.
    Sie könnten mal noch ein Firmwareupdate versuchen. Ansonsten erstellen Sie bitte ein Ticket.
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  2. #12
    Join Date
    01.11.2020
    Posts
    2

    Default

    I have tried to address the Profilux 3ex via USB

  3. #13
    Join Date
    03.11.2020
    Posts
    1

    Default

    I have a new computer that does not have a serial interface.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •