Results 1 to 5 of 5

Thread: Switch channels not showing Amp reading

  1. #1
    Join Date
    08.09.2020
    Posts
    22

    Default Switch channels not showing Amp reading

    Hi
    I have 4 devices connected to the PAB but only three are showing the electrical consumption.

    The third plug which is connected to my Aqamai wave maker it has a registered consumption of between 4-10 watts. Any reason why this doesn’t show it’s consumption?
    The PAB plug is not faulty as it shows results for other appliances.

    Thanks


    Sent from my iPhone using Tapatalk

  2. #2
    Join Date
    12.04.2015
    Posts
    364

    Default

    10 watt / 230 Volt = 0.04 Ampere

  3. #3
    Join Date
    08.09.2020
    Posts
    22

    Default Switch channels not showing Amp reading

    Quote Originally Posted by Gandalf View Post
    10 watt / 230 Volt = 0.04 Ampere
    Are you say that because it’s using 0.04 amp, that it won’t register on the GHL application ?


    Sent from my iPhone using Tapatalk

  4. #4
    Join Date
    08.09.2020
    Posts
    22

    Default

    Bump


    Sent from my iPad using Tapatalk

  5. #5
    Join Date
    09.11.2017
    Posts
    1,476

    Default

    Quote Originally Posted by Elic173 View Post
    Are you say that because it’s using 0.04 amp, that it won’t register on the GHL application ?
    Correct, the minimum is approximately 0.1-0.2A
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •