Page 2 of 2 FirstFirst 12
Results 11 to 16 of 16

Thread: Issue with power loss and level sensor

  1. #11
    Join Date
    12.08.2020
    Posts
    52

    Default

    Just to be clear, the sensors are now connected to my expansion box.

  2. #12
    Join Date
    09.11.2017
    Posts
    1,476

    Default

    We will check and adjust the firmware. You have a ProfiLux 4?
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  3. #13
    Join Date
    12.08.2020
    Posts
    52

    Default

    Yes.

    Sent from my SM-G988U1 using Tapatalk

  4. #14
    Join Date
    12.08.2020
    Posts
    52

    Default

    Is there an ETA for this fix? I'm heading out to vacation in December and am worried about power outages.

  5. #15
    Join Date
    09.11.2017
    Posts
    1,476

    Default

    No, it is not yet clear when the fix will be ready.
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  6. #16
    Join Date
    15.11.2020
    Posts
    3

    Default

    Hello, just to confirm I am experiencing a similar behavior with one opto level sensor in an ATO setting. After reset it will just start. I fixed for now with a delay on the socket, but probably this should not be happening.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •