Just to be clear, the sensors are now connected to my expansion box.
Just to be clear, the sensors are now connected to my expansion box.
We will check and adjust the firmware. You have a ProfiLux 4?
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Yes.
Sent from my SM-G988U1 using Tapatalk
Is there an ETA for this fix? I'm heading out to vacation in December and am worried about power outages.
No, it is not yet clear when the fix will be ready.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Hello, just to confirm I am experiencing a similar behavior with one opto level sensor in an ATO setting. After reset it will just start. I fixed for now with a delay on the socket, but probably this should not be happening.
Bookmarks