Results 1 to 3 of 3

Thread: Difference between flush measurement cell and end measurement cell

  1. #1
    Join Date
    31.05.2016
    Posts
    21

    Default Difference between flush measurement cell and end measurement cell

    What is the difference between these two options?

  2. #2
    Join Date
    09.11.2017
    Posts
    1,476

    Default

    You mean the difference between flush and empty measurement cell?

    "Flush measurement cell" does flush (fill and empty) the cell. THis is recommended to run after a pH sensor calibration or after running "Vent internal reagent tube".
    "Empty measurement cell completely" does empty the measurement cell. You should use this function if there is water left in the measurement cell after a measurement, e.g. if a measurement was cancelled.
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  3. #3
    Join Date
    31.05.2016
    Posts
    21

    Default

    Thank you.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •