Results 1 to 4 of 4

Thread: Upgrading from 3 3x to 4 ?

  1. #1
    Join Date
    02.09.2020
    Posts
    3

    Default Upgrading from 3 3x to 4 ?

    Hello everyone,

    I have a question if anyone knows it would be greatly appreciated.

    I have a profilux controller model 3 3x controlling lots of equipment through 5 pabs.

    Is it possible to upgrade to the new profilux 4 but keeping the same pabs and current configuration? meaning if I back up all settings can I just change the controller and upload my settings from file? would that work?

    thank you for your time

    Kostas

  2. #2
    Join Date
    27.05.2015
    Posts
    2,488

    Default

    Hello Kostas,

    Although you can still use the existing 5 PAB-devices, transferring settings over to a P4 would not be doable since these are different products with different hardware. The most efficient way to transfer these over to the P4 is to connect to both at the same time using GCC and do a split screen view to copy the settings from the P3.

  3. #3
    Join Date
    02.09.2020
    Posts
    3

    Default

    Thank you for your reply.
    So just to make clear the new profililux 4 can communicate with my previous generation powerbars, just need to remove older profilux, connect new model and do a complete set up from beginning, correct ??

  4. #4
    Join Date
    27.05.2015
    Posts
    2,488

    Default

    Yes.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •