Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: How to program the Profilux to fill a mixing container?

  1. #11
    Join Date
    09.11.2017
    Posts
    1,499

    Default

    You don't need to connect the Maxi Doser to a Powerbar, you can set the dosing pump to react to a switch channel.

    To just stop dosing until the salt water tank is refilled, you could do the following:
    1. Create a new timer and add your dosing schedule there via switchmode 'Manu. dosing' or 'Auto. dosing'
    2. Create a new prog. logic with Input 1: The new timer and Input 2: Your SR_FLIPFLOP prog. logic INVERTED
    3. Assign the new prog. logic to a free switch channel
    4. Configure the dosing pump to react to this swicth channel


    But this will abort the water change and you may need to correct the filling level of your tank manually after refilling the saltwater.
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  2. #12
    Join Date
    12.08.2020
    Posts
    52

    Default

    So that works with a couple of adjustments.
    1. Each doser needs a separate timer, as they have slightly different speeds.
    2. The other logic still needs to be built in before the timers.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •