Results 1 to 4 of 4

Thread: probe calibration

  1. #1
    Join Date
    19.08.2020
    Posts
    4

    Default probe calibration

    i read in a lot of posts that you can read de real value of ph when calibrate the probe (4 y 7), but in the calibration i can only read de ADC value!
    how and where can i see the ph value to confirm the calibration is right?

  2. #2
    Join Date
    09.11.2017
    Posts
    1,476

    Default

    During calibration the pH value can't be displayed, because both calibration steps needs to be completed before a correct value can be displayed.
    You can check the calibration after it's done by opening the sensor page or the KH Director page (for the KHD pH sensor, at the bottom of the page).
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  3. #3
    Join Date
    19.08.2020
    Posts
    4

    Default

    Quote Originally Posted by Thilo View Post
    During calibration the pH value can't be displayed, because both calibration steps needs to be completed before a correct value can be displayed.
    You can check the calibration after it's done by opening the sensor page or the KH Director page (for the KHD pH sensor, at the bottom of the page).
    i'm sorry but I don't understand at the bottom of the page i read in this moment pH 5,88 and ADC1 49345 and ADC2 28122 in this moment....its correct?
    so...i've to check this value just after the calibration?the second one is pH7 so i'll have to read pH 7 ther in that moment?

  4. #4
    Join Date
    09.11.2017
    Posts
    1,476

    Default

    After calibration you can put the sensor in the calibration fluids and check if the actual value is displaying 4/7 pH after a view minutes to verify the calibration.
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •