-
Tunze with ProfiLux Stream Function
Hi
I have got the Tunze 6095 and the Tunze 1 cable. Now my Tunze is connected to Power bar S1 and the Tunze 1 cable is connected to L1/L2 port.
I want to achieve the following:
1. When I press on tile "Feed Pause 1" it should shut off my Tunze Wave Maker and the Return Pump connected to S2 in Power Bar.
2. I want to control the stream function through Stream 1 group throughout the day and night.
Now this is what my setup in GCC:
System >> Switch Channels and outlets >> S1 (Power bar) (Tunze is set to "Always On")
System >> 1-10V interface >> L1 - Function - set as Stream - 1
Processes >> Time 1 >> Number 1 starts at 8PM (All Days selected and Switch Mode is Manual). Setting for Dosing is manual 60ml/minute (i dont know what exactly this is for)
Extras >> Stream Group 1 >> Nocturnal enabled start at 11PM, end at 7AM
Mode - Random Min Duration 0:20:00 - Max duration 7:00:00
Waves - Sinus Waves - Min wave duration 5 second max 10 seconds
Random Wave reduction 80%
Pump Assignment - 1
Behavior during feed pause is set to "Off"
Reacts on Feedpause all selected 1,2,3,4
When I am selecting Feedpause tile in the App, the feedpause is activating in the PL4 and app, but the Tunze isnt stopping...
Please help.
-
Hi,
Is your Timer function activating the feed pause?
Check the Tunze controller and make sure it is set to 3rd party control mode.
-
I skimmed through the entire manual of Tunze 6095 and failed to find any option for activating Third Party control.
Please note that, I connected using GHL Tunze 1 cable. The pump shows the voltage in the 1-10 V interfaces.
My problem is I cannot see any affect on the nocturnal stream, nor it shut off during Feedpause. I have also disabled the timer option.
My question is Tunze is in powerbar S1 and Tunze 1 is connected through L1 port. Is there anything I should check and change? Powerbar S1 will remain "Always On"? Or select Stream Pump and Function 1?
Currently under 1-10V interface L1 is set to Stream Pump Function 1.
Under Switch Channel S1 is set to Always On.
-
There is no need to have the Tunze pump connected to a powerbar. All control is done through the Tunze1 cable.
Disconnect the pump's power cable and connect it to a normal outlet.
Contact the pump manufacturer if you do not know how to enable 3rd party control. The instructions should be in their manual.
-
Thanks Vinny!
However I purchased two powerbars to connect all my equipment through these. GHL powerbar is one of the hardiest powerbar i have ever seen. Kudos!
So it is necessary to disconnect and bring in a normal socket to control the pump? There is no way I can keep it connected to the powerbar and control through L1 of 1-10V interface?
-
Yes, that's perfectly doable.
Just set this socket to the Always ON function.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks