Results 1 to 4 of 4

Thread: Doser 2.1 firmware update to 1.35 problem

  1. #1
    Join Date
    21.07.2020
    Posts
    2

    Default Doser 2.1 firmware update to 1.35 problem

    Just update a Doser 2.1 to version 1.35 and now it won't dose anything. Its dead. Looking at the container in the software, I see its full but it says there are 0.0 days left and the average daily dose is also 0.0

  2. #2
    Join Date
    09.11.2017
    Posts
    1,476

    Default

    Are the dosing schedule and the weekdays still set?
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  3. #3
    Join Date
    27.05.2015
    Posts
    2,488

    Default

    Depending on what FW version you were coming from, if it was a large jump or large upgrade, the doser may have reverted back to factory settings. For this reason we always recommend backing up your settings prior to updating to prevent issues like this. Go through your dose schedule settings and make adjustments where necessary.

  4. #4
    Join Date
    21.07.2020
    Posts
    2

    Default

    Thank You both for pointing me in the right direction. The schedule was all there so I stupidly assumed the days of week were also. They weren't.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •