Results 1 to 4 of 4

Thread: ATO/AWC via pumps controlled by 1-10v interfaces?

  1. #1
    Join Date
    07.06.2020
    Posts
    2

    Default ATO/AWC via pumps controlled by 1-10v interfaces?

    Hi everyone,

    I have recently invested in some GHL equipment, including a Profilux 4, which is absolutely fantastic. I was wondering if it is possible to set-up an ATO/AWC system using pumps controlled by the 1-10v interface? I've got some 5v pumps I intend to control this way but the ATO/AWC doesn't appear under the function drop-down for the 1-10v interface in the control centre.

    Thanks very much!

  2. #2
    Join Date
    12.04.2015
    Posts
    364

    Default

    it is possibile to conigurate the 1-10 V intervace in the way that it is limmitet to 1-5 V.
    But I would recoment you to use 2 10K Resister to devide the Voltage by 2.
    But this is only to control the pumps NOT to maintaine them. the Current of the Interface is limitet to a few mA.

  3. #3
    Join Date
    07.06.2020
    Posts
    2

    Default

    Thanks very much for the help. Ahh I didn't realise the current was so limited. Oh well nevermind, I'll probably have to use the sockets then.

  4. #4
    Join Date
    10.10.2013
    Posts
    994

    Default

    In any case, you will not be able to assign an ATO / AWC function to a 1-10V interface so it is useless.
    ATO/AWC is with switch channels or GHL Doser only.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •