Results 1 to 5 of 5

Thread: Questions for doser maxi about ATO, AWC.

  1. #1
    Join Date
    13.10.2016
    Posts
    59

    Default Questions for doser maxi about ATO, AWC.

    Hallo.

    I have just set up a doser maxi controlled by a Profilux 4. And it works very well :-)
    Question 1: Second pump on the maxi doser are used to dose some water from the aquarium/sump to a bucked, next to the aquarium, to compensate for elevated NaCl buildup caused by dosing balling salts. When I need to empty the bucked can I then take the hose from the sump and then use the maxi doser reverse function and empty about 20 liter in another bucked. Will dosing 20 liter at high speed on reverse damaged the maxi dose?

    Question 2: Do you recommend a way to suck up water from the sump so I won’t get debris/ small objects from the aquarium water that could block the hose ?

  2. #2
    Join Date
    09.11.2017
    Posts
    1,476

    Default

    The reverse dosing can be used as intensively as with the normal dosing direction.

    To avoid sucking in small objects it is, of course, best to place the hose so, that it cannot suck in any dirt. Otherwise you can use a filter.
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  3. #3
    Join Date
    13.10.2016
    Posts
    59

    Default

    Ok :-)

    One more thing. I am also using the doser maxi as ATO. Is it possible to program the Profilux in a way so the doser will dose more water each time it is activated by the sensor in the sump. And by this way have a little longer time between each ATO-water-dosing.

  4. #4
    Join Date
    12.04.2015
    Posts
    364

    Default

    yes it is you need a programmable logik with tje funktion delay off x seconds and your ato. asaign this to anbunused switch channel and your doser to this awitch channel.

  5. #5
    Join Date
    13.10.2016
    Posts
    59

    Default

    Could you explain this again, it did not work :-)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •