Results 1 to 4 of 4

Thread: Kh director stopped working after installing new slave pumps

  1. #1
    Join Date
    12.11.2019
    Posts
    31

    Default Kh director stopped working after installing new slave pumps

    Hey
    I have installed a new slave dosing pump before one week and from then the kh director stopped testing and in my touch screen i see the last number 7.7 from the day i installed the new dosing pump.
    Today i found that the profilux don’t have the kh director assigned so i make a new assign and i try to start testing and it don’t respond and i have done a new calibration to kh director probe and after that tried to make the test again and it don’t work....
    And after that i have problems in the profelux tuch screen that sometimes goes wrong letters and numbers for 3 seconds then its goes back ok and again the same problem.
    Thank you

  2. #2
    Join Date
    12.11.2019
    Posts
    31

    Default




    Sent from my iPhone using Tapatalk

  3. #3
    Join Date
    12.11.2019
    Posts
    31

    Default




    Sent from my iPhone using Tapatalk

  4. #4
    Join Date
    09.11.2017
    Posts
    1,477

    Default

    Please open a ticket and tell us the firmware versions of the devices: https://www.aquariumcomputer.com/sup...ets-enquiries/
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •