Results 1 to 2 of 2

Thread: I’ve messed up

  1. #1
    Join Date
    27.02.2020
    Posts
    8

    Default I’ve messed up

    Hi guys I was trying to get my connect app to work when I was out of the house and stupidly changed the ip address on the settings for my p4 and it disconnected from the app instantly now I cannot get back on. I’ve tried the factory reset on the controller hoping to start for scratch but it doesn’t reset the hotspot name so it still says p4 hotspot and I just cannot connect to it. Any ideas

  2. #2
    Join Date
    04.11.2015
    Posts
    1,062

    Default

    The wifi-module configuration is not reset directly, when the factory settings have been loaded.
    In order to get the P4 default hotspot back, you'll need to use the button 'WPS Start...' in GHL Control Center on the Communication page. After doing this, the hotspot should return after 1-2 minutes.

    All further information and resources covering the network configuration can be found on our Knowledge Base:
    https://www.aquariumcomputer.com/kno...d-wifi-module/
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •