Hope this is the correct section of the forum to post this in.

One reason for buying the P4 was to monitor my tank but the primary reason was to control my heater and prevent the tank getting cooked. I had a huge loss of fish and corals when the other controller I was using for my heater failed and the non-thermostatic I had heater cooked the tank.

So I have a TMC heater in the tank at the moment which has an led display and is set to 26 degrees. I want to use the Profilux 4 to make sure the heater power gets cut out at say around 28 degrees to hopefully prevent another issue in the future.

Can anyone advise on the settings in GHL control centre for this?

Thanks