Greetings all.
I'm trying to control a diy led set up using my p3 and the v2 controller. The driver is from blueacro
AcroIQ MicroDriver v2
48V, 2 channel, 400-1000mA adjustable current with PWM
The AcroIQ MicroDriver driver is a mere 2.6 x 0.7 inches, offers two current adjustable channels with PWM dimming, and can mount right next to your LEDs on T-slot or other heatsinks. Capable of 48V supply voltages, the driver is fully compatible with any 3.3V or 5V PWM dimming signal from off-the-shelf controllers from blueAcro or others
It has two channels. I can get the LEDs to respond but it doesn't seem to be working correctly.
Do I need a specific power supply to connect to the v2?

Is the issue that the driver pwm voltage is lower than the v2 pwm voltage?