Results 1 to 3 of 3

Thread: PROBLEM with: LEDControl4 V2 with MeanWell ELN-60-48D drivers

  1. #1
    Join Date
    01.05.2019
    Posts
    2

    Default PROBLEM with: LEDControl4 V2 with MeanWell ELN-60-48D drivers

    Hello all!
    Just purchased a LEDControl4 V2 for my Profilux3N eX.
    I want it to work with my DIY lamp!
    I have a lamp connected to 4 MeanWell ELN-60-48D drivers (https://www.meanwell-web.com/en-gb/a...c-eln--60--48d), wiring (http://www.topledlight.com/images/v/...4053331650.jpg)

    I know everything about my DIY LED lamp works since I have had it connected to a corallux storm with 10V ANALOG CONVERTER so it has run PVM (1-10 V) no problem before!

    I followed the manual and connected it like this:
    Udklip2.PNG

    Manual looks like this:
    Udklip.PNG

    DC connected to output, L1L2 + L3L4 connected to profilux - under system-> 1-10V-Interface L1-L4: all was operating at 10V just to test, but NOTHING happened, no lights no nothing?
    I'm pretty much in the dark to what I have done wrong.

    The only thing I'm in doubt of is on the meanwell there is a Dim(-) and a Dim(+) while in the LEDControl4 V2 manual refer to PVMin and GND(-) - are the meanwell even compatible with the module?

    I'm also abit in doubt about the pullups ? I don't think it is needed with this driver but I'm not sure? Please help me!

  2. #2
    Join Date
    04.11.2015
    Posts
    1,061

    Default

    Hello,

    there is a thread that might help already getting your issue solved:
    https://forum.aquariumcomputer.com/s...n-LED-Control4
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  3. #3
    Join Date
    01.05.2019
    Posts
    2

    Default

    Seems like I have to put a pullup on! Well, getting my hands dirty again and hopefully it will work!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •