Results 1 to 7 of 7

Thread: Powerbar6 still dead :-(

  1. #1
    Join Date
    22.04.2019
    Posts
    12

    Default Powerbar6 still dead :-(

    Guys i need help this is driving me crazy!

    Like I wrote before, by a mistake I upload a wrong firmware to my powerbar6. Now it’s not working at all. The GHL support send me the correct firmware but I cannot figure out have to pushed it to the powerbar when the ProfiLux can’t find the pab unit. Please we the video hope some one can help.

  2. #2
    Join Date
    22.04.2019
    Posts
    12

    Default

    Video

  3. #3
    Join Date
    27.05.2015
    Posts
    2,486

    Default

    1. Connect to your ProfiLux via USB
    2. Disconnect ALL PAB devices, except the Powerbar-6E
    3. Make sure the powerbar is powered ON
    4. Click the Extras tab and select Firmware update in the PAB section
    5. For emergency update purposes, restart the powerbar when prompted to do so.

  4. #4
    Join Date
    22.04.2019
    Posts
    12

    Default

    I followed all the steps and like last time, everything went well until the re-start off the ProfiLux. Then it just goes dark besides the ghl logo (like last time). But this time I knew have to bring back so did an emergency reboot and got it back. The powerbar6 is just as it were before not responding at all? Are there a reset button on the powerbar? Can you assess my ProfiLux it is online? To se what course the conflict?

  5. #5
    Join Date
    22.04.2019
    Posts
    12

  6. #6
    Join Date
    27.05.2015
    Posts
    2,486

    Default

    There was no need to restart the ProfiLux because you are doing an emergency update only on the Powerbar.
    If you clicked the EXTRAS tab at the top of the GCC screen, there will be 2 options that say "Firmware update". You must choose the one that is in the PAB device section, NOT MAINTENANCE. It will allow you to load the firmware to the powerbar.

    Please follow the steps closely as mentioned earlier.
    If the problem persists, open a support ticket.

  7. #7
    Join Date
    22.04.2019
    Posts
    12

    Default

    Problem solved. I’m a computer moron! Things working perfectly now.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •