Bug in GCC 1.1.2.9? problems with dose pump speed settings

[MatthiasF]

Gaël is right,

speed setting is only enabled, if a Doser2 assigned to the PAB-system.

[Lasse]

Thank you - that´s explain it. But in my 3.1T - I´m able to set a speed even if no dose2, 2.1 or dos max is connected - and further on - if I use the app or GHL connect - I can set speed in P4 too - even if there is no Doser 2, 2.1 or dos max connected. It is only in GCC and P4 - that it not works to set speeds if dos 2 or dos 2,1 is not connected

Sincerely Lasse

[Thilo]

I can't say why it isn't disabled in GCC when using a P3@6.43, we would have to check this first. But GHL Connect currently doesn't check if a Doser is connected and does always enable this option.

[Lasse]

I was wrong, it will be grayed out even in P3.1 if no doser above 2 or maxi doser is connected. But it is for all 16 dosers in GCC even if it is only attached to doser 1-4 (in GCC)

Sincerely Lasse